SOYO SY-6BA+ Bedienungsanleitung PDF herunterladen (Seite 30)

Hardware Setup SY-6BA+ III

(d) Vcore Voltage Adjust

The CPU notifies the board of what core voltage it requires by its

VID outputs. The on-board voltage regulator uses the VID code to

set the core voltage. If the Vcore Voltage Adjust is set to normal,

the Vcore will be exactly what the VID code specifies. If an

adjustment percentage is selected the Vcore will be that percentage

higher than the VID code specifies. For instance the CPU VID code

specifies 2.0V and the Vcore Voltage adjust is set to +10.0% the

actual CPU Voltage will be 2.2V. This function should only be used if

the CPU is running on FSB Frequencies beyond the CPU

specifications, note that SOYO does not guarantee system stability

if this item is not set to normal.

Don’ t forget to raise the upper limit of the CPU Vcore monitoring

voltage in the Hardware Doctor utility if Vcore is set to higher

voltage than VID specifies.

o Normal o + 2.5 % o + 5.0 % o + 7.5% o +10.0 %

Step 4. Select [SAVE & EXIT SETUP]

Press <Enter> to save the new configuration to the CMOS memory,

and continue the boot sequence.

Troubleshooting at First Start

l What should I do if the Motherboard refuses to start?

The 350MHz setting is used as default so whenever the BIOS

settings are erased or reset, the board will be able to boot up.

If the CPU frequency was set too high and the Motherboard refuses

to start up, you can always load the default values by pressing the

[Ins] key during boot up.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 73 74

Keine Kommentare

SOYO SY-6BA+ Bedienungsanleitung Seite 30