SOYO SY-6BA+ Bedienungsanleitung PDF herunterladen (Seite 26)

Hardware Setup SY-6BA+ III

Step 17. Power-On by Keyboard Jumper (JP10)

You can choose to enable the Power-On by Keyboard function by

shorting pin 1-2 on jumper JP10, otherwise, short pin 2-3 to disable

this function.

Power-On by

Keyboard

Enable Disable

JP10 Setting

Short pin 1-2 to enable

the Power-On by

Keyboard function.

Short pin 2-3 and the

Power-On by Keyboard

function is disabled.

Note: When using the Power-On by Keyboard function,

please make sure the ATX power supply can take at least

720mA load on the 5V Standby lead (5VSB) to meet the

standard ATX specification.

Step 18. Power On

You have now completed the hardware installation of your

Motherboard successfully.

1. Turn the power on

2. To enter the BIOS Setup Utility, press the <DEL> key while the

system is performing the diagnostic checks,

Note: If you have failed to enter the BIOS, wait until the boot

up sequence is completed. Then push the RESET button and

press <DEL> key again at the beginning of boot-up, during

diagnostic checks.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 73 74

Keine Kommentare

SOYO SY-6BA+ Bedienungsanleitung Seite 26